The versatility of Pneumatic excessive pressure grouting pumps

Peumatic Grouting pump is designed for pressure and filling grouting of cement and bentonite slurries. It is primarily used for injecting (grouting) bar anchors and the drill holes in order to reinforce the unfastened rock mass. The most grain dimension can not exceed zero.2 mm.
Grouting pump operation and upkeep is straightforward, secure and dependable. This pump is used in mines operating under tough conditions as a result of it’s reliable and explosion-proof.
Basic Pneumatic Grouting pump embody: An air inlet, the pneumatic cylinder, mounting base frame and stand, strain gauge, pumping cylinder, outlet with fast release coupling and wheels.
How it works
Pneumatic strain within the air cylinder exerts a excessive stress on the grout combination which leads to ejection of grout with a high stress and velocity. The valves of the air cylinder in the pump function routinely to actuate the cylinder. The pneumatic cylinder then strikes the plunger up and down to complete the pumping cycle.
Pneumatic grout pump can be pushed even with out Electrical power supply in remote areas by using engine pushed compressor.
The pump is majorly used in building and mining trade for injecting materials into wide and medium measurement gap in beams, columns ,basement walls and flooring, lift shaft concrete wall fill-up and so forth. In mining business it is used to refill cement resolution the place there is a hole exists between construction and rock and for soil stabilization.
Detachable design tends to easy upkeep and transportation. Challenging works like Grouting in Bridges.
READ: How hydraulic submersible pumps work
This pump is widely used in tunnels, coal mine, bridges and dams, constructing foundation, and different underground initiatives, and inflammable, explosive websites and different unhealthy surroundings.
It has software in chemical industry additionally to pump out chemical slurries.
The pump is electrical energy free so, can be utilized at any web site situation whether it is rural or urban.
Mining Pneumatic Grouting pump has a bigger discharge slurry adjustment vary. Generally the ultimate amount of the grouting volume is eight or10 times of the amount to start with. And the ultimate grouting amount proves that filling is compacted.
Simply put; Pneumatic high-pressure grouting pump is specifically designed for high-pressure grouting. And it adopts full hydraulic drive, it’s strain and circulate may be adjusted based on the necessities of grouting,(The flow of grouting pump is 0-100L/min, strain of discharge is 0-10MPa).besides, This Pneumatic high-pressure grouting pump can be utilized for grouting single or double fluid.
High-pressure grouting pump is mainly used for highways, railways, water and electricity, building, mining and so on. ground/underground building.
Mining Pneumatic Grouting pump has the advantages of low power consumption, small vibration, low noise, small dimension, high effectivity, dependable efficiency, strain and circulate control, long life and so on. compound gauge ราคา grouting pump has pneumatic injection pump, dual fluid injection pump, extrusion injection pump and piston injection pump.
Pneumatic grout pump can be Light weight and with a wheelie design it can be carried easily. It is designed for straightforward operation and low upkeep. Last but not least its spare parts are easily obtainable.

Scroll to Top